With the purchase of every PrintDry filament dryer you will receive two FREE gifts inside. First it an additional top feeder for the top chamber, so that you filament will easily turn and help with feeding the filament directly to your printer.
Second is two (2) FREE D-Spools. These D-spools feature a open top and bottom and allows the filament dryer to reach more of the filament on the roll. This is important especially in longer prints. You can un-spool the filament from the manufacturers spool and wind it onto one of your FREE D-spools. We have created a Re-spooling station and have this offered on our website for purchase.
Below is a detailed description on how to assemble the D-Spools. Please refer to the D_spool_assembly highlighted below.
Contains: 2 large spools
3 center posts with large center hole
3 center posts with small center hole
6 screws
Look at the large spools. One side with have an indentation where a screw will go, this is considered the outside of the spool.
The inside of the spool will have three short raised posts which will accept the center posts with the large center holes.
TO ASSEMBLE
Place a screw though the outside opening and attach the center posts with the small holes. Do this on one spool only. Total of 3 posts and 3 screws
.
Lay the spool on a flat surface with the center posts pointing up. Slide on the center posts with the larger center hole on the raised post. There should now be 6 center posts sticking upwards.
Align the second large spool so that the center posts with the large posts line up with the raised posts on the inside of the second large spool.
Align the remaining three center posts with the holes that will accept screws. Tighten all three posts with the remaining 3 screws.
Your D- spool is now completed and the center posts should be parallel with the other side
Repeat steps above to assemble the second D-spool that is included with your filament dryer.
